The MTS Loco Decoder III is designed for easy installation in locos with the LGB “DCC interface”. It can power up to two LGB motors, which also makes it useful for installations in older LGB locomotives without decoder interfaces. Decoder-equipped locos can be used both on digital and analog layouts. The decoder is equipped with two lighting and six function terminals, overheating/overload protection, programmable special functions and a connecting cable for the new LGB “DCC interface”. Technical data: - max. load (total): 4 amp - max. load (motor terminal): 3 amp Overview of functions (see also LGB 55006): - loco addresses 1-10239 can be programmed - 14 or 28 drive steps, 128 drive steps are supported - “Back-EMF“ function (analog and digital) can be adjusted to suit your loco - serial and parallel control of all lighting and function terminals - programmable flashing lights and short-term functions - programmable simulated wheel sensor These functions and others can be programmed using the Universal Remote (LGB 55015) or the MTS PC Decoder Programming Module (LGB 55045).